Gentec-eo FLASH Manuel d'utilisateur télécharger pdf (Page 13)

Revision 1.5 9

2.3 Wavelength selection (CO2 / YAG / Other)

The default wavelength is YAG. If there is a calibration at

another wavelength, the default wavelength is the calibrated

one.

To change the wavelength, press and hold the button

for 3 seconds. After 3 seconds, the FLASH displays the text

« Prog » and changes the active wavelength to the next one

(Other).

The new wavelength (CO2 / YAG / Other) flashes for 3

seconds, then the device returns to the normal display (last

measure).

To select the 3

wavelength available (CO2), you must repeat

the same procedure (long press of 3 seconds…).

The new selection is stored in the FLASH’s nonvolatile memory.

Note: The wavelength selection function is not available when

the FLASH is in “Ready” or “Measure” mode.

YAG

Other

2.4 User’s self calibration (see Appendix A for typical wavelength correction factors)

Wavelength selection (section 2.3) shall be performed first to

select the appropriate wavelength mode (CO2 / YAG / Other).

(1) To adjust the sensitivity of the FLASH, first take a

measurement as described above.

Note: The self calibration is not available when the FLASH is in

“Ready” or “Measure” mode.

CO2

(2) When the measurement is completed, press and hold

simultaneously the 2 buttons and for 3

seconds to enter the self calibration mode.

 State 2.1 : The FLASH displays the text « CAL » for 1

second.

 State 2.2 : Then it displays the correction factor for 1

second.

The correction factor’s default value is 1.000 for the 3 modes

(CO2 / YAG / Other). Factory calibration also sets the correction

factor for the newly calibrated wavelength to 1.000.

State 2.1

State 2.2

CO2

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Pas de commentaire

Gentec-eo FLASH Manuel d'utilisateur Page 13