Gentec-eo FLASH Manuel d'utilisateur télécharger pdf (Page 11)

Revision 1.5 7

WARNING:

WHEN ‘’HOT’’ APPEAR ON THE SCREEN TURN OFF THE LASER BEAM IMMEDIATELY

TO PREVENT DAMAGING THE DETECTOR

Be careful not to exceed the maximum levels and densities stated in the specifications.

The handle on the flash is for carrying purposes only. It is not recommended for the

user to hold the Flash during measurements. Extreme caution must be taken during

laser power measurement.

Gentec-EO is not responsible for any damage or injury caused by misuse.

2.1 Activation of the device and measuring the power of a laser

(1) Place the FLASH on the measurement surface.

(2) Press the button once, to turn the FLASH on.

 State 2.1 : The FLASH turns on and does a lamp test (all

segments of the LCD, the backlight and the 2 LEDs are ON).

 State 2.2 : Displays the software revision number. The 2

LEDs and backlight are OFF.

 State 2.3 : Displays the last measurement taken. The 2

LEDs and backlight are still OFF.

If you hold the button during the startup, the FLASH will

display the software revision number until the button is released.

It is recommended to leave the FLASH stabilize for 30 seconds

after startup before starting a new measure.

Do not turn the FLASH on with the laser on.

State 2.1

CO2

YAG

Measure

Ready

Other

State 2.2

State 2.3

CO2

(3) Press the button once, to reset the FLASH and

start a new measure.

The FLASH displays the icon « Ready » and « ---- » waiting

to detect an increase in temperature (the laser signal). The

2 LEDs are OFF.

Note : The only way to exit this mode is to make a measure or to

shut down the device (see step (6)).

CO2

Ready

(4) When the FLASH detects an increase in temperature

(the laser signal), it automatically starts the measure,

displays the icon « Measure » and a countdown of the

number of seconds remaining to complete the

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Gentec-eo FLASH Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Dispositifs optiques Gentec-eo FLASH