Gentec-eo Beamage-M2 Manuel d'utilisateur télécharger pdf (Page 42)

Beamage-M

User Manual Revision 2.0 42

Figure 4-2 Full rotation around the first spot

Then, adjust your setup to place the first spot on the left-hand side of the screen.

Figure 4-3 Adjust Setup to Place the First Spot on the Left-Hand Side of the Screen

4.4. There are less than 10 visible beams

It could be hard sometimes to get a good compromise between obtaining the minimum of 10 beams and a good

range around the minimum beam waist position.

The first thing to do to get more beams is to bring the beams closer together by using the Y-ADJ screw on the

Beamage-M2 module. This screw changes the distance of a mirror and thus affects the number of visible beams.

Figure 4-4 Y-ADJ Screw Alignment to Change the Distance Between the Beams

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48 49 50

Pas de commentaire

Gentec-eo Beamage-M2 Manuel d'utilisateur Page 42