Gentec-eo TUNER Manuel d'utilisateur télécharger pdf (Page 14)

TUNER User’s Manual Revision 4.2 13

3 BATTERIES

3.1 Battery selection

To avoid leakage and poor autonomy, it is highly recommended that only good quality, new and identical

alkaline batteries be put into the TUNER. Good quality rechargeable batteries can also be used with the

TUNER and recharged with an external charger.

The batteries need to be replaced if the TUNER displays “LO Batt” on its digital display or if it does not

power-up when the I/O control key is pressed.

3.2 Battery installation

- Put the TUNER face down on a flat surface.

- Lift the kickstand.

- Open and remove the battery door.

- Insert one battery in the nylon strap (to ease later removal) and insert it at one extremity of the TUNER

battery compartment with the right polarity. To avoid intermittent contact and involuntary disconnection,

firmly insert the batteries. Insert the other batteries over the nylon strap with the right polarity so that

pulling on the strap will pull every battery out of the TUNER.

- Put the battery door back in place.

3.3 Battery removal

- Put the TUNER face down on a flat surface.

- Lift the kickstand.

- Open and remove the battery door.

- Hold down the TUNER and slowly pull on the nylon strap to remove the batteries. Do not use a pointed

tool to remove the batteries, since that could puncture them. The batteries need a firm pull to be

removed.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Gentec-eo TUNER Manuel d'utilisateur Page 14