Gentec-eo TUNER Manuel d'utilisateur télécharger pdf (Page 12)

TUNER User’s Manual Revision 4.2 11

Fig. 1-4 Needle Display in Tail mode

Fig. 1-5 Needle Display in Bar Graph mode

When the batteries are discharged enough to compromise the measurement, the TUNER displays “LO

BATT” instead of the measurement. Refer to section 3 to replace the batteries.

If the voltage supplied by the external power supply is lower than 7 Volts, the TUNER displays “LO

JACK”.

If no detector head is connected when the TUNER is powered on, the message “No Detector” will be

displayed. Turn off the TUNER; connect the detector to the Probe Input Jack (see section 1.4) and turn

the TUNER on again.

If the detector is not recognized by the TUNER, the message “Bad Detector” will be displayed. Make sure

you use a detector head that is compatible with the TUNER (see section 1.2 for the list of compatible

detector heads).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Gentec-eo TUNER Manuel d'utilisateur Page 12