7
Revision 1.1
THZ-D Series Instruction Manual Gentec Electro-Optics Inc. All rights reserved
2.2 THZ-D Series “SMART INTERFACE” CONNECTOR
The DB-15 male “Smart Interface” connector contains an EEPROM (Erasable Electrical Programmable
Read-Only Memory) programmed with the calibration sensitivity and other data related to the specific
THZ-D
wattmeter in use. Faster set-ups are obtained because the monitor automatically adjusts to the
characteristics of the wattmeter, when the “Smart Interface” is connected to the monitor.
The DB-15 “Smart Interface” connector pin-out is (see Fig. 1-1):
1- USED BY MONITORS
2- " " " "
3- " " " "
4- " " " "
5- " " " "
6- “+” SIGNAL OUTPUT
7- ‘’-’’ SUPPLY VOLTAGE THZ9D ONLY
8- USED BY MONITORS
9- ‘’+’’ SUPPLY VOLTAGE THZ9D ONLY
10- USED BY MONITORS
11- " " " "
12- " " " "
13- “-“ SIGNAL OUTPUT
14- USED BY MONITORS
15- " " " "
SHELL- COAX. SHIELD / BODY GRND
NOTE : Verify with Gentec-EO for supply voltage requirements.
Commentaires sur ces manuels